Articles on: ISMOD NANO

My ISMOD NANO is always vibrating

If your ISMOD NANO is always vibrating, try the following steps:

Reset the device according to the image below
Make sure the heating pin is properly cleaned
Disassemble the device and clean it properly

If this didn't work, kindly contact our Support Team on cs@ismodeurope.com

Reset

It is always recommended to do a basic cleaning daily and thorough clean after every pack. To learn how to clean your device: Clean Your Device

It is also recommended to have some extra pins with you, and these would be good to change them every few months (2 - 3 months) to get the optimal heating performance. Nano is the only device where you can change the heating element yourself, they are available in packs of 2 on our website, and this will ensure that the heat transfer is always optimal.

Updated on: 17/12/2021

Was this article helpful?

Share your feedback

Cancel

Thank you!